Nothing in Co-Create is built until you approve it. You can approve a single bullet, every bullet under a header, and choose whether Remy guesses or asks when something is unclear.
6 min readUpdated October 3, 2026
Before you approve
The project needs an app linked to it, because that is where the code goes.
Building uses credits. If your balance is too low, Co-Create tells you when you tap approve and offers to buy more. Nothing is greyed out ahead of time.
If Remy has open questions on a bullet, answering them first gives you a better build. You can still approve without answering.
Approve one bullet
In Stacks, open the bullet's menu and choose Approve.
In the Approve feature for coding window, tap Prompt for Claude Code to read the prompt Remy will work from. You can edit or copy it there, then tap Done.
Choose how Remy should handle what the bullet does not say (see below).
If a picture would help, tap Attach screenshots and add the screen to change. Screenshots are optional. Then tap Yes, approve. The bullet's badge changes to Kicked off… and then Coding… with a timer.
Open the bullet's menu, choose Approve, pick how questions are handled, and review the prompt.
Approve a whole header
Open the header's menu and choose Approve all bullets.
Each session gets its own prompt: one per bullet, or one per checkpoint if you group bullets. Tap Prompt for Claude Code to see them; when there is more than one, tap the numbered chips to switch between them and edit any of them.
Pick how the section should run: In order or Approve in parallel.
Tap Yes, approve.
Approve all bullets gives every checkpoint its own prompt, with numbered chips to switch between them.
Bullets that are already approved, or are being prepped, are left out and listed under Not included in this approval. Approving a header twice never builds the same bullet twice.
Guess or ask: the two approval types
Approve (use intuitive defaults): Remy resolves anything unclear itself, notes the assumption and keeps going. Fastest, and right most of the time.
Approve + ask me questions: when Remy hits something it cannot settle from the bullet, it sends you every open question at once and waits. You get a notification, answer in the app, and the same build carries on.
The two approval types sit at the top of every approve window.
If you edited a prompt by hand and then switch approval type, Co-Create asks before rebuilding the prompts, so your edits are never lost silently.
In order, with checkpoints
In order builds the bullets one after another. Each finished step is deployed to your preview, so a long section can mean many deploys. Checkpoints let you group bullets so one build session covers several of them and deploys once.
Under Checkpoints, use the minus and plus buttons to choose how many sessions to split the section into. Co-Create suggests a number based on the size of the work; tap Use suggested to go back to it.
Each checkpoint row shows which bullets it covers. Use End ↑ and End ↓ to move a boundary one bullet at a time.
Read the summary line under the picker. It says how many deploys you will get.
Choose how many checkpoints to use and move the boundaries with End up and End down.
Every bullet keeps its own badge. If a checkpoint could not finish one of its bullets, that bullet is retried on its own.
Approve in parallel
Approve in parallel starts one build per bullet, all at the same time. Use it when the bullets do not depend on each other. Each one is merged into your app as it finishes, and a bullet that fails is retried after the rest.
If the approval did not go through
Any problem is shown inside the approve window as Approval not sent, with the reason. Your prompts stay as you left them, so you can fix the issue and try again.